Tagging of isobars using energy loss and time-of-flight measurements

D. Shapira, T. A. Lewis, P. E. Mueller

Research output: Contribution to journalArticlepeer-review

Abstract

The technique for tagging isobars in a mixed beam by measuring energy loss by time-of-flight has been tested. With this method, isobar separation should improve by allowing more energy loss (thicker absorber), but only if one can control absorber homogeneity. Measurements of beam energy loss and energy spread obtained under such conditions were shown to be close to predicted values using both collisional and charge exchange contributions to energy straggling. The calculation of energy straggling allows us to study the efficacy of this method for isobar separation when applied to different mass ranges and beam energies. Partial separation in a most difficult case, an analyzed beam of A = 132 isobars at energies near 3 MeV/A, has been demonstrated. The time-of-flight information can be added online as an additional tag to the data stream for events of interest. Such event-by-event tagging enables one to study the effect of differences in isobaric mixture in the beam on the reaction outcome even when isobar separation is not complete.

Original languageEnglish
Pages (from-to)1204-1208
Number of pages5
JournalIEEE Transactions on Nuclear Science
Volume49 II
Issue number3
DOIs
StatePublished - 1 Jun 2002
Externally publishedYes

Keywords

  • Energy loss measurements
  • Isobars
  • Particles separation and tagging
  • Radioactive ion beams
  • Time-of-flight measurements

ASJC Scopus subject areas

  • Nuclear and High Energy Physics
  • Nuclear Energy and Engineering
  • Electrical and Electronic Engineering

Fingerprint

Dive into the research topics of 'Tagging of isobars using energy loss and time-of-flight measurements'. Together they form a unique fingerprint.

Cite this