Abstract
The factors that influence the formation of helium blisters in copper were studied, including crystallographic grain orientation and thermomechanical conditions. Helium implantation experiments were conducted at 40 KeV with a dose of 5 × 1017 ions/cm2, and the samples were then subjected to post-implantation heat treatments at 450 °C for different holding times. A scanning electron microscope (SEM) equipped with an electron backscatter diffraction (EBSD) detector was used to analyze the samples, revealing that the degree of blistering erosion and its evolution with time varied with the crystallographic plane of the free surface in different ways in annealed and cold rolled copper. Out of the investigated states, rolled copper with a (111) free surface had superior helium blistering durability. This is explained by the consideration of the multivariable situation, including the role of dislocations and vacancies. For future plasma-facing component (PFC) candidate material, similar research should be conducted in order to find the optimal combination of material properties for helium blistering durability. In the case of Cu selection as a PFC, the two practical approaches to obtain the preferred (111) orientation are cold rolling and thin layer technologies.
Original language | English |
---|---|
Article number | 260 |
Journal | Metals |
Volume | 14 |
Issue number | 3 |
DOIs | |
State | Published - 1 Mar 2024 |
Keywords
- crystal orientation
- dislocations and vacancies
- helium blistering
- plasma-facing components
- thermo-mechanical state
ASJC Scopus subject areas
- General Materials Science
- Metals and Alloys